Table of Contents
Advertisement
•
Power cord is used as a disconnection device:
disconnect the power cord.
•
Electrical-type class 1 equipment:
must be connected to a properly wired earth ground socket outlet. An improperly
connected socket outlet could place hazardous voltages on accessible metal
parts.
•
Pluggable equipment:
should be easily accessible.
•
the air vents must not be blocked on the unit and must have free access
Air vents:
to the room ambient air for cooling.
•
Operating temperature:
temperature of 40
•
All countries:
codes.
•
Laser beam
Installing the Multichannel Media Converter as a Standalone Unit
The media converter can be installed as a standalone unit (for instance, on a table) or in a
standard 19-inch rack. To install the unit in a rack, refer to "Installing the Multichannel Media
Converter in a Rack" on page 14.
to install the media converter as a standalone unit, perform these steps:
1.
Remove all equipment from the shipping package and store the package in a safe
place.
______________________caution_______________________________________
Do not remove the dust covers from the fiber optic ports on the multichannel media
converter until you are ready to connect the cables. Dust contamination can adversly
impact the operation of the fiber optic ports.
___________________________________________________________________
2.
Select a level, secure surface for the media converter.
3.
Remove the adhesive protecting sheet from the rubber feet included with the unit and
affix the feet to the corners on the bottom of the media converter, approximately 1
centimeter from each edge.
4.
Place the device horizontally on a hard, clean surface (for example, a table or desk),
leaving free space around it for ventilation.
5.
______________________note__________________________________________
Do not place the unit on other active, heat generating equipment and avoid placing
other devices on top of the media converter.
__________________________________________________________________
6.
If you purchased an optional S.CON/PS redundant power supply, install the unit by
following the directions included with the unit.
______________________note________________________________________
Do not remove the panel covering the expansion slot for the S.CON/PS unit unless
you intend to install the unit.
the socket outlet should be installed near the equipment and
this product is designed for a maximum ambient
o
C.
install this product in accordance with local and national electric
warning: do not stare into the laser beam.
this equipment must be earthed. The power plug
9
to de-energize equipment,
Advertisement
Table of Contents
