Periods Of Non-Operation; Troubleshooting - Zanussi ZBB27450SV User Manual

A certain amount of frost will always form on the
freezer shelves and around the top compartment.
Defrost the freezer when the frost layer reaches a
thickness of about 3-5 mm.
1. Switch off the appliance, or pull out the
electrical plug from the wall socket.
2. Remove any stored food, wrap it in several
layers of newspaper and put it in a cool place.
WARNING! Do not touch frozen
food with wet hands. Hands can
freeze to the goods.
3. When defrosting is completed, dry the interior
thoroughly and keep the scraper for future use.
4. Switch on the appliance.
Wait at least 3 hours before putting the food back
into the freezer compartment.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
The appliance does not oper-
ate.
The appliance is noisy.
The lamp does not work.
The compressor operates con-
tinually.
8

PERIODS OF NON-OPERATION

When the appliance is not in use for long periods,
take the following precautions:
1. Disconnect the appliance from electricity
supply.
2. Remove all food.
3. Defrost (if necessary) and clean the appliance
and all accessories.
4. Clean the appliance and all accessories.
5. Leave the door/doors open to prevent
unpleasant smells.
Possible cause
The appliance is switched
off.
The mains plug is not con-
nected to the mains socket
correctly.
There is no voltage in the
mains socket.
The appliance is not suppor-
ted properly.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incorrect-
ly.
Many food products were
put in at the same time.
The room temperature is too
high.
WARNING! If you want to keep the
appliance switched on, ask somebody
to check it once in a while to prevent
the food inside from spoiling in case of
a power failure.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical ap-
pliance to the mains socket.
Contact a qualified electrician.
Check if the appliance stands
stable.
Close and open the door.
Refer to "Replacing the lamp".
Refer to "Operation".
Wait some hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.