Sharp 8M-B70AU Setup Manual page 22

Names of Monitor Parts and Remote Control Buttons
Parts of the Monitor
 Front
POWER lamp
• Green light ON: In
operation
• Red light ON: In standby
• OFF: Power off
 Main body controls
Power button
MENU button
INPUT button
• On the Setup menu => "Enter" button
 forward/ backward buttons
• On the Setup menu => "Upward/Downward
cursor" button

• " " button functions as "Upward cursor", and

" " button functions as "Downward cursor".
Volume (+/-) buttons
• On the Setup menu => "Right/Left cursor" button
• "+" button functions as "Right cursor", and
"-" button functions as "Left cursor".
If a message "The operation with remote control is prohibited" appears on the screen
Release the lock using the operation buttons on the main body.
1) Press the home button on the main body.
2) Select Setup using the volume buttons on the main body and then press the INPUT button.
3) Select Ecology > "Operation Lock" using the volume buttons and selection buttons, and
then press the INPUT button.
4) Select Off and press the INPUT button.
Brightness sensor/remote control receiver
=> Page EN 1
• Point the remote control unit toward this part.
 Rear
Input 7 A~D (HDMI)
• 8K signal terminal
Input 6
Digital audio output terminal
(optical)
Input 4 (HDMI)
LAN terminal (10BASE-T/100BASE-TX)
• Use this terminal for IP control, etc.
EN 7
Headphone jack
(3.5 stereo mini jack)
• Audio can be output from the speakers even
when headphones are connected. (Refer to
"Menu Operation" in the built-in Operation
Manual.)
USB1 terminal
• Use this terminal to view photos, music, and
video stored in USB memory.
USB2 terminal
Input 1 to 3 (HDMI)
Input 5
Audio input: Input 1/Input 6/Input 7
Analog audio output terminal
(3.5 stereo mini jack)