Release 7/2009 Ver. 1.0
1.2.4.2 Mounting Stands
Floor mounting stands are available for use where the
guard cannot be mounted directly to the machine.
P/N 0957
Supplied with:
1. 5 ft. item 40m m X 40m m extrus ion
2. 1-bas e s tand.
3. 1-40m m X 40m m end cap.
4. 2-T s lot nuts M5.
5. 2-M5 X12m m hex head.
6. 2-M5 s pring lock was hers .
3 lev eling bolts
7. 2-flat was hers 5/5.3m m .
3/8" holes
8. 2-5/16 bolts .
9. 3-3/8 24 x 1/2" hex head.
The mounting stand set includes a floor-mounted base
into which the 5-foot mounting post can be secured.
The floor base is steel and can be permanently mounted
to the floor surface with the pre-drilled mounting holes.
The post is extruded aluminum with slots to allow the
light curtain to be positioned anywhere along its length.
The mounting stands are supplied with all of the
necessary hardware to facilitate mounting a standard
GS-120 light curtain. Leveling bolts allow for minor
adjustments to the floor stand orientation.
TAPESWITCH CORPORATION
100 Schmitt Boulevard
Farmingdale, New York 11735
Technical Manual: GS-120 Light Curtain Systems
1.3
ORDERING INFORMATION
Part numbers for the various models are shown in the
table on the right. To fully specify a model and its
options use an order code as shown in sections 1.3.1
and 1.3.2 on the following page.
Model Number
GS-120/8"(208mm)/30
GS-120/12"(308mm)/30
GS-120/16"(408mm)/30
GS-120/24"(608mm)/30
GS-120/32"(808mm)/30
GS-120/36"(908mm)/30
GS-120/40"(1008mm)/30
GS-120/48"(1208mm)/30
GS-120/56"(1408mm)/30
GS-120/64"(1608mm)/30
GS-120/72"(1808mm)/30
GS-120/24"(608mm)/70
GS-120/32"(808mm)/70
GS-120/40"(1008mm)/70
GS-120/48"(1208mm)/70
GS-120/56"(1408mm)/70
GS-120/64"(1608mm)/70
GS-120/72"(1808mm)/70
GS-120-4
GS-120-3
GS-120-2
7
Part Number
0801
0802
0803
0804
0805
0806
0807
0808
0809
0810
0811
0821
0822
0823
0824
0825
0826
0827
0828
0829
0830
Phone: 631-630-0442
Fax: 631-630-0454
www.tapeswitch.com