Table of Contents
Advertisement
DISPLAY
1
TECHNICAL DATA
Voltage: 220-240 V ~ 50-60Hz
Absorbed power: 2000 W
Dimensions LxHxD; 490x445x300
Weight: 11.586 Kg
INSTALLATION AND FIRST USE
•
Before using the oven for the first time, remove any paper
and other material inside of it such as protective cardboard,
booklets, plastic bags, etc.
•
Make sure the appliance has not been damaged during
transport.
•
Place the appliance on a flat, solid surface-
Remove any object from above the appliance. Do not use
on surfaces that can be damaged by heat.
•
Wash all accessories thoroughly before using, by hand or in
the dishwasher, except for the crumb tray which must be
washed by hand.
The crumb tray must be inserted in the oven, at the bottom
of the chamber, below the bottom heating element.
•
The appliance must be kept at a distance of at least 20 cm
from the mains power socket to which it is connected.
Before operating the appliance, move it 10 cm away from
the wall and any object found on the same work surface.
Cooking time
indicator/
2
clock
Selected
3
function icon
•
Before using for the first time, operate the oven empty
with the thermostat at maximum and in CONVECTION
Temperature/
mode for at least 30 minutes to eliminate the "new" smell
4
weight
and any smoke caused by the presence of protective sub-
indicator
stances applied to the heating elements before transport.
Air out the room.
SETTING THE CLOCK
When the appliance is connected to the power outlet for the first
time or after a power outage, it emits a beep and the display
shows four lines ("--: --"). After 5 seconds the display turns off
since the time of day has not been set and the appliance goes
into stand-by mode. To set the clock, proceed as follows:
Press the START button (H) for at least 3 seconds (fig. 2).
The time will start to flash (00:00).
Set the time by turning the timer knob (G) (13:00).
Press the START button (H).
The minutes will start to flash (13:oo).
Adjust the minutes by turning the timer knob (G) (13:26).
Press the START button (H).
The set time is displayed(13:26).
If you wish to change the time later, repeat the procedure above.
The appliance must be in stand-by mode in order to be able to
change the time.
5
10 cm
Min
10 cm
Min
20 cm
Min
Advertisement
Table of Contents
