Setting Up Your Traktor Kontrol Z2 System; Before You Begin; Connecting The Power Supply - Native Instruments Traktor Kontrol Z2 Setup Manual

4

Setting Up Your TRAKTOR KONTROL Z2 System

This chapter covers how to connect the devices and get your TRAKTOR KONTROL Z2 system
up and running.
4.1

Before You Begin

Before connecting the devices, and setting up your TRAKTOR KONTROL Z2, here are some
points to be aware of:
▪ Make sure that you have installed the hardware driver with the TRAKTOR software instal-
ler before you connect the Z2 to your computer! For this, please follow the instructions
specific to your operating system in chapter
▪ The Z2 may not work properly connected to a USB hub! Connect it directly to a USB port
on your computer.
▪ The Z2 — in combination with a power amplifier, speakers, or headphones — can pro-
duce sounds in decibel ranges that may cause hearing damage. Also, switching off the de-
vice with the volume control set to a high level may damage your loudspeakers. Always
make sure the volume faders on the Z2 are set to minimum before connecting the power
supply, connecting external equipment, playing music, or switching the device on/off.
Once everything is connected and set up, gradually raise the volume while music is play-
ing until you reach the desired listening level.
4.2

Connecting the Power Supply

To connect the power supply:
Setting Up Your TRAKTOR KONTROL Z2 System
↑2, Software Installation.
TRAKTOR KONTROL Z2 - Setup Guide - 33
Before You Begin