Operating The C•Que 8; Setting Up The C•Que 8 - Samson Cque 8 Owner's Manual

Operating the C•que 8
SETTING UP THE C•que 8
Setting up your C•que 8 Headphone Amplifier is a simple procedure, which takes only a few minutes.
Remove all packing materials (save them in case of need for future service) and plug the provided AC adapter
cord in the rear AC inlet, but don't plug the power cable into a wall outlet just yet.
• Connect the output from the device you want monitored to the Left/Right LINE INPUT jacks on the C•que
8 rear panel. The C•que 8 accepts both balanced and unbalanced signals. Generally, a balanced signal
is preferable because it provides better signal-to-noise ratio and reduced extraneous noise.
• Set the controls to the following positions:
MAIN
OL
0
0 10 L R -6
VOLUME BALANCE
-12
-18
-24
INJECT
2 CH STEREO
MASTER VOLUME – Off
ST/2CH SWITCH – Out
MASTER BALANCE- Center, 12:00
• Turn the master Volume knob and all four headphone Channel Output knobs to their minimum (fully
counterclockwise) setting.
• Plug the C•que 8 power adapter into a wall outlet and switch the unit on by pressing the power switch.
• Apply a signal, like the output of a mixer playing a CD, to the C•que 8's rear-panel Left/Right LINE
INPUT jacks. Raise the master VOLUME until the main meter reaches -18 to -12 dB.
• Connect a set of headphones to Channel 1 and slowly turn the channel's Volume knob clockwise until
you hear the desired level.
WARNING: Because the C•que 8 is capable of generating extremely high volume levels, always start with the
channel Volume knob at minimum and then slowly turn it up.
CH 1
CH 1 CH 2
OL
0
0 10 -6
VOLUME
SHAPE OUT
-12
SHAPE OUT
-18
-24
0 10
CH 2
VOLUME
CHANNEL 1 VOLUME – 0
CHANNEL 1 SHAPE SWITCH- Out
CHANNEL 2 - 4's Controls - Set the Same as Channel 1
6
CH 3
CH 3 CH 4
OL
0
0 10 -6
VOLUME
SHAPE OUT
-12
SHAPE OUT
-18
-24
0 10
CH 4
VOLUME
4 CHANNEL
HEADPHONE AMP