Appendix A: Operating The Mixpad 12/9 Off Battery Power - Samson MIXPAD Owner's Manual

Appendix A: Operating the
MIXPAD 12/9 off Battery Power
The MIXPAD 12 and MIXPAD 9 can optionally be battery powered.
This requires the use of two 12 Volt rechargeable Lead-Acid (Gelcell)
batteries, connected to the rear panel AC connector, wired as shown in
the illustration below. These batteries will provide the necessary bi-polar
voltages needed to operate and maintain excellent audio quality.
M9/M12 Connector
Standard 5 Pin DIN (MIDI) Connector
-12V Ground
Male
"T" Connector
(2 pieces)
20cm
Jumper
(2 pieces)
Ground
All Batteries .187" Male Quick Disconnect
1 m
1 piece
Male
All Quick Disconnects are Female except
where noted. All Male and Female Quick
Disconnects are fully insulated and .187"
Rear View of Connector for soldering
1 3
45º
4 5
2
+12V
"T" Connector
34
20cm
Phantom Power
+12V
-12V
Ground
Ground
Female .187" Quick Disconnect
Male .187" Quick Disconnect
Pin 1 = +15V
Pin 2 = Ground
Pin 3 = Ground
Pin 4 = -15V
Pin 5 = Phantom Power
Phantom Power
Jumper