Lubrication; Parts And Service; Parts And Service Information - Bad Boy 48031001 Operator's Manual

3. Make sure all shields are in place and in good
condition. Repair or replace any missing or damaged
shields.
4. Perform lubrication per paragraph 4-2.
5. Listen for abnormal sounds, which might indicate
loose parts, damaged bearings, or other damage.
Correct any deficiency before continuing operation.
6. With the engine off, engage the blower assembly.
Check the belt tension and inspect the pulley belt for
cracks or tears.
7. Check for wear or deterioration of the upper or lower
hoses. If there are any portions of the hose that have
been torn or worn through, replace with genuine
Bad Boy parts.
After Each Use:
1. Clean all debris from machine especially from the
container, underneath the belt shields, and safety
decals. Replace any missing or illegible decals.
2. Inspect the unit for worn or damaged components.
Repair or replace before the next use. Any
replacement component installed during repair shall
include the component's current safety decal specified
by the manufacturers to be affixed to the component.
3. Check belt for proper tension.
THE SERIAL NUMBER PLATE
IS LOCATED ON THE TOP
ASSEMBLY P#(A0551)
Unit Model Number:
Unit Engine Size:
Unit Serial Number:
Date of purchase: _____/_____/_________
Dealer/Distributor Name:
Dealer's/Distributor's: _______________________ State: __________ Zip: ___________
Phone Number: ____________________________
Phone #: (828) 684-1234 or Toll Free: (800) 438-5823
PECO
OUTDOOR POWER EQUIPMENT
Model Number
Serial Number
Arden, North Carolina 28704
_____________________________
_____________________________
_____________________________
________________________________________
Address: PECO Inc.
P.O. Box 1197
Arden, NC 28704
Email: peco@lawnvac.com
16

4-2 Lubrication

NOTE: Use only white lithium based grease for
lubrication of the shaft on the blower assembly.
1. On initial use: Grease the fitting on the blower shaft.
2. Every 25 hours of use: Re-grease the grease fitting.
3. Every 200 hours of use: Check oil levels in gear box.
Oil in gear box should cover the gears. If not, fill using
an EP90 weight oil. 6oz. will fill the gear box from
empty.
SECTION V

PARTS AND SERVICE

5-1 Parts And Service Information

Bad Boy collection system owners should record the
name and telephone number of their Service Center.
Your Service Center will be happy to supply replacement
parts, accessories, and do any service or repairs to your
collection system. If for any reason your Service Center
is unable to service your collection system or supply
replacement parts, contact PECO and include the
following information on the chart below.
WRITE THE MODEL AND
SERIAL NUMBER IN THE
BOX ABOVE FOR FUTURE
REFERENCE.