Table of Contents
Advertisement
2-7 Upper Frame Assembly
Installation
NOTE: During this step, it is suggested that two people
install the upper frame to the lower mount tube.
Using two people to lift the upper frame, lift the upper
frame above the lower mount tube making sure the
frame is pointing away from the mower (Figure 9). Slide
the upper frame tube into the lower mount tube aligning
the mounting hole. Insert (1) ½" x 2-1/2" clevis pin
P#(K0133) through the hole and fasten with (1) 5/32" x
2-5/8" hair pin clip P#(K0088).
Figure 9.
Lower Mount Tube
2-8 Top Assembly To Upper Frame
Assembly Installation
Align the pivot brackets of the top assembly P#(A0551)
to the pivot point on either side of the upper frame
assembly. Place (1) P#(K0041) fender washer between
each pivot point (Figure 10) and fasten each side by
using (1) P#(K1153) 5/16"-18 x 3/4" HHCS and (1)
P#(K1180) 5/16"-18 nyloc nut. When fastening leave nut
slightly loose so that the top can pivot freely.
Figure 10.
Fasten w/
(1) ½"x 2-1/2" Clevis Pin
(1) Hair Pin Clip
Upper
Frame
Top Assembly Here
Fasten w/
(1) 5/16" x 3/4" HHCS
(1) 5/16" Nyloc Nut
(1) Fender Washer
Per Side
2-9 Boot To Mower Deck Installation
60" Boot Plate Mounting Instructions
To mount the boot plate P#(B0184) to the boot
P#(E1113) use (2) 3/8"-16 x 1" carriage bolts P#(K1182)
and (2) 3/8"-16 flange nuts P#(K1215). See Figure 11 for
bolt placement.
48" & 52" Boot Plate Mounting Instructions
To mount the boot plate P#(B0184) to the boot
P#(E1113) use (2) 3/8"-16 x 1" carriage bolts P#(K1182)
and (2) 3/8"-16 flange nuts P#(K1215). See Figure 12 for
bolt placement.
NOTE:
When bolting the boot and boot plate together,
the head of the bolt is placed from the inside of the boot.
This will prevent grass from collecting on the bolts.
For All Deck Sizes
Remove the bolts that hold the deflector shield in place
so that the boot rod can fasten the boot and boot plate to
the mower deck. Align the holes in the boot plate to the
holes in the deflector shield mount and slide the boot rod
P#(B0244) through and fasten by using (1) hair pin clip
P#(K0099).
NOTE:
The mower's deflector shield is removed in the
following photo for clarity. Always have the deflector
shield mounted when mowing.
Figure 11.
Boot Plate
Boot
11
Boot
Fasten w/
Rod
(1) Hair Pin Clip
Fasten w/
(2) 3/8" x 1" Carriage
Bolts
(2) 3/8" Flange Nuts
Hide quick links:
Advertisement
Table of Contents
