Figure 6-3: Add A New Data Logger Configuration - Focal 923 User Manual

6.2.3.2 Add a New Data Logger Configuration
To add a new card configuration to the list:
1. Click the button at the far left of the Connection Manager.
2. Enter a Description, Serial Port, Modbus Node and Refresh Interval for the new card, as depicted in the
figure below.
3. Click "Save Configuration".
Notes:
1. It is recommended to set the "refresh interval" to >= 1000 ms.
2. The default node is 1.
6.2.3.3 Connect and Disconnect Diagnostic Communications
Click
Click
Note:
If on start up a configuration tab is already open, the configuration shown corresponds to the last configuration
used. This configuration may not apply for the current system. This could result in connection failures to the
923-EDL. It is recommended that on start-up, any existing and unknown configuration tabs are closed and new
configurations are added or ensure the same configuration is always used.
Focal Technologies Corporation
A Moog Inc. Company

Figure 6-3: Add a New Data Logger Configuration

to begin retrieving data from the card.
to disconnect from the card.
Model 923 Data Logger – User Manual
Document No: 923-0603-01, Rev. 2
Page 6-4