Silent Alert CO4A-2230-EU MkII Quick Start Manual

Quick start guide CO4A-2230-EU MkII
Wireless Carbon Monoxide Alarm

Standard operation

Ei
CARBON
MONOXIDE
ALARM
2.
Ei
CARBON
MONOXIDE
ALARM
The unit should be replaced by this date or after 5 years of service, whichever is sooner.
4.
All new receivers will display the signal with a
blue light. This is to allow the user to
distinguish between a smoke alarm signal
standard fire signal and the key will
6.
Status lights
Screw mounting
holes
Battery
compartment
Test button
Press and hold the
test button.
The alarm will sound and a
signal will be sent to the
Pager or SignWave.
The Carbon Monoxide alarm has an expiry date on the side.
and a Carbon Monoxide alert.
Older receivers will receive a
light red.
If a low battery is detected alarm
will chirp, a signal will be sent to
the Pager or SignWave and the
battery powered light will
shine green every 45 seconds.
Replace with Alkaline or Lithium
AA batteries only.
Press and hold the test button to
check the unit operates correctly.
Any questions? Call us on +353 (0)1 247 9007
1.
READ THE SUPPLIED INSTRUCTIONS
PRODUCED BY EI ELECTRONICS BEFORE
Ei
CARBON
MONOXIDE
ALARM
3.
5.
7.
S i lent
Alert
USING THIS GUIDE
Remove the battery tab by
pulling out and away from
the unit.
The status lights on the
front of the unit will light in
sequence to indicate the
unit is starting up.
Slide the battery
compartment cover off
Ei
CARBON
MONOXIDE
and remove.
ALARM
Using the screws
provided mount the unit
according to the
separate Ei
electronics instructions.
When Carbon Monoxide
Ei
is detected the alarm will
CARBON
MONOXIDE
ALARM
sound, a signal will be
sent to the Pager or
SignWave and the alarm
light will shine red.
If a fault in the alarms circuitry
is detected, the alarm will
chirp, a signal will be sent to
the Pager or SignWave and
the fault light will shine amber.
The unit will need to
be replaced.
TM