Silent Alert KF3A-2219-EU-GFOB Quick Start Manual

Quick start guide
Emergency person to person keyfob with shock detection

Standard Activation

1 2 3 4 5 6 7 8
2.
KF3A-2219-EU-GFOB

Shock detection activation

The KF3A-2219-EU-GFOB
sensor which will trigger the unit automatically when the device
receives a shock.
WARNING! Your device and its accessories are not toys. They may contain small parts. Keep them out of the reach of small children.
KF3A-2219-EU-GFOB
Status light
Send button
Configuration
switches
Battery
Security screw
Battery cover
Neck cord

Sending a signal

The supplied lithium battery
should provide a large number
of activations
Press the send button.
The status light will shine green
and the Pager or SignWave
should receive a person to
person signal.
If the light shines orange when
the button is pressed the internal
battery is low and should be
replaced (see step 3).
variant incorporates a
Any questions? Call us on 01246 450789
1.
Remove and
Discard
1 2 3 4 5 6 7 8
3.
Unscrew here
For best results we recommend the using the neck
cord provided to allow the keyfob to hang around the
neck. Placing the keyfob in a pocket may reduce the
effectiveness of the shock sensor.
A battery is already installed in the Keyfob.
To activate the unit
simply remove the paper
tab by pulling it gently
away from the unit.
The keyfob is now ready
to go and is set to
illuminate person to
person by default.

Low battery

When the battery needs replacing
remove the screw from the rear of
Turn the unit over and gently push
the battery cover upwards
exposing the battery and
configuration switches.
Replace with a 6V lithium battery
(2CR1/3N OR PX28L)
1 2 3 4 5 6 7 8
Silent
Alert
TM
the unit.