Maintenance - Patio Glow ARX13200 Assembly Instructions Manual

9. Restore your gas supply and check ALL of the connections for leaks using a solution of
soapy water. If a leak is discovered and any bubbles are seen, close the main gas valve and
re-tighten ALL the connections. NEVER USE A FLAME TO CHECK FOR GAS LEAKS!
10. Stick the conversion label on the rating plate as shown in Figure 6.
Serial Number _________________
CAUTION: The gas pressure regulator provided with this appliance must be used. This regulator is set for an outlet pressure of
This appliance has been converted to use Natural Gas. Input 40,000 Btu/hr.
Max Gas Supply Pressure 7 inch w.c. (1.74 kPa) Min. Gas Supply Pressure 5 inch w.c. (1.24 kPa)
Minimum clearance from combustible constructions: Sides: 24 in.609 mm. Top 72 in. 1828 mm.
FOR OUTDOOR USE ONLY. If stored indoors, detach and leave cylinder outdoors.
The flames should look like those in Figure 7. To clean the burner,
use a soft brush after the burner has cooled completely. Never use
a vacuum cleaner on the burner. It is recommended to store the
fire pit indoors during winter if it will be subjected to freezing
temperatures. The LP cylinder must be disconnected and
removed from the appliance before the appliance can be stored
indoors.
Metal Rating Plate
1.
2.
3.
4.
5.
6.
7.
Figure 17
Figure 6

MAINTENANCE

9
Step5
WT17YP4
Model Number:
Conversion Label
Conversion Label
Figure 7