Latched Alarm - TC Communications TC8614 User Manual

Chapter 4 Tutorial
4.2

Latched Alarm

The front panel "ALM", "BPV", "CRC" and "SYNC" LEDs can display both
current and latched error conditions.
For example, if the "ALM" LED is on, and "SYNC" LED blinks twice, it indicates
that there are two "T1/E1 sync loss" after the last alarm reset.
To reset the alarm, press and hold the "R2" ("Reset Too") button for 3 seconds until
the "ALM", "BPV", "CRC", and "SYNC" LEDs are flashing. The alarm will reset
after the "R2" button is released.
See the table below for latched alarm definitions,
LED
ALM
BPV
CRC
SYNC
TC8614 Rev 1.4 User Manual
Normal Current Error
Off Flashing
Continuously
Off Flashing
Continuously
Off Flashing
Continuously
On Flashing
Continuously
Latched Error Note
On
Blink The number of blinks
indicates the number of
times the error condition
happens. (Max. 3 Blinks)
Blink The number of blinks
indicates the number of
times the error condition
happens. (Max. 3 Blinks)
Blink The number of blinks
indicates the number of
times the error condition
happens. (Max. 3 Blinks)
Latched Alarm
4-2