Overhead Rigging
DMX connection
◆
Connection between laser lights and DMX must use the shied cable of diameter more than 0.5mm.
Please use the attached 3 pin XLR plug/socket to connect the DMX output/input interface. The
connection between socket and cable as below( note the plug/socket's 3 pin number and position).
XLR mounting-sockets(rear view):
◆
Note, XLR plug/socket's 3pin can not be touched by inner hull, connection between pins is not
allowed. Except above connection, XLR plug/socket can not be connected with XLR control line.
Device receives international standard DMX512(1990) control signal.
◆
When using standard DMX512 control signal, the last device's output interface must
be connected to a DMX plug. This plug is putting a 120 ohm resistance between
"canon" plug's 2 pin and 3 pin. Showing as below pic. Sticking this plug into the last
device's signal output interface, it will avoid the interference during the process of
signal transmission.
Mess
DMX-output
1-Shield
2-Shield(-)
2
1
3-Shield(+)
3
276.85
4
DMX-input
XLR mounting-plugs(rear view):
2
1
3
PIN3
PIN2