Overhead Rigging - Scandlight DJ LED Diamond User Manual

Overhead Rigging

Attention! The installation must be carried out by qualified service personal only. Improper installation can
result in serious injuries and /or damage to property. Overhead rigging required extensive experience!
Working load limits should be respected, Certified installation materials should be used, the installed
device should be inspected regularly for safety.
◆
Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
◆ Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The
fixture must be fixed at least 50cm from surrounding walls
◆
The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
◆
The device should be well fixed; a free swinging mounting is dangerous and may not be considered!
◆
Do not cover any ventilation opening as this may result in overheating
◆
Before the first time use, it must be inspected by professional staff to make sure safety, inspection regularly
every year..
Never expose the lens to direct sunlight, even for a short period, This may damage the light effect or even
cause fire!
AC Power
Please use the attached power, note that power voltage
and frequency are the same as the marked voltage and
frequency of device when connecting power. Every device's
power should be connected separately, so that device can
be controlled individually.
The power cord specification table:
Cable(EU)
Brown
Liht blue
Yellow/Green
Cable(US)
Black
White
Green
3
L E N
Pin International
Live
Neutral
Earth
FUSE: 5×20mm
250V 1A slow
L
N