NETGEAR WN1000RP User Manual page 22

Extender (Booster) IP Info
• MAC Address. The physical address of the booster, as seen from the local area network
(LAN).
• IP Address. The IP address of the booster. The default is 192.168.1.250.
• DHCP Server. Identifies the network DHCP server on the wireless network.
• IP Subnet Mask. The IP subnet mask associated with the LAN IP address of the booster.
The default is 255.255.255.0.
• Gateway IP Address. The IP address of the wireless network gateway.
• Domain Name Server. The IP address of the Domain Name Server (DNS) of the
wireless network.
Extender (Booster) Wireless Settings
• Name (SSID). The name (SSID) of the wireless network.
• Region. The location where the booster is operating.
• Channel. The channel of the wireless network.
• Wireless AP. On or Off.
• Broadcast Name. On or Off.
• Wi-Fi Protected Setup. Configured.
Show Statistics
Scroll to the bottom of the Status screen, and click Show Statistics. The following screen
displays:
The screen shows statistics for wireless LAN (WLAN) ports. For each port, the screen
displays the following:
• Status. The status of the port.
• TxPkts. The number of packets transmitted on this port since reset or manual clear.
• RxPkts. The number of packets transmitted on this port since reset or manual clear.
• Collisions. The number of collisions on this port since reset or manual clear.
• Tx B/s. The current line utilization—percentage of current bandwidth used on this port.
• Rx B/s. The average line utilization for this port.
• Up Time. The time elapsed since the last power cycle or reset.
• Poll Interval. Specify the poll interval frequency. If you change this value, click Set
Interval so that your change takes effect.
WiFi Booster for Mobile WN1000RP
Network Settings
21