IDEAL LANTEK 7G Quick Reference Manual

Section 4: Cable Type Setup
28. Highlight Twisted Pair Perm,
27. Press Shift & F4 or highlight
Cable Type icon and press Enter. press Enter.
29. Highlight desired Cable Test 30. Display will revert to Ready
Standard, press Enter. screen, Cable Type updated.
Section 5: FIELD CALIBRATION
31. Press F3 or highlight the Field 32. Connect Remote Patchcord
Calibration icon, press Enter. between the two units, press F1.
Cable & Network Standard Reference Table
Supported Cabling Operation
Network Application Standards Frequency
10BaseT CAT3* 10 MHz
Rx on pair 3,6
100Base-Tx CAT5* 80 MHz
Rx on pair 3,6
1000Base-T** CAT 5*/5E 80 MHz
(half duplex)
1000Base-TX CAT 5E/6E 250 MHz
(full duplex)
10GBase-T CAT6A (draft) 500 MHz
* The information for CAT3 & CAT5 is for reference only. They are both considered to be obsolete.
** To operate on Category 5/5e cable, 1000Base-T systems use complex and expensive noise cancellation circuitry and cost more money than 1000Base-Tx systems which require Category 6 cable.
Wiring Configuration Figure 1
33. Disconnect Remote Patchcord, 34. Disconnect Display Patchcord
connect Display Patchcord from Remote Handset, Connect
between units, press F1. Remote Patchcord to Remote
Handset, press F1 on Display
Handset, press Autotest on
Remote Handset.
35. Calibration Complete, 36. Tester is now setup for CAT 6
press Escape. Test Standard, to be saved in
Compact Flash on Slot 1, the
For more calibration procedures, current job selected is IDEAL
visit www.idealindustries.com
INDUSTRIES INC, Cable ID
starts at "TEST 0001. "

Pass/Fail Reporting

You are now ready to perform an AUTOTEST on the cable you have setup.

Power-Up

Individual Autotest Results
Overall test result is a pass. All values pass with sufficient margin.
Overall test result is a fail. One or more values fail.
or — Pass or fail by a small margin.
Wire Cabling
Used Bandwidth
Tx on pair 1, 2 16MHz
Rx on pair 3,6
Tx on pair 1,2 100MHz
Rx on pair 3,6
Tx & Rx on all 4-pairs 100 MHz
Tx & Rx on all 4-pairs 250 MHz
Tx & Rx on all 4-pairs 500 MHz
Wiring Configuration Figure 2
®
LANTEK LAN Cable Testers
Quick Reference Guide
For more calibration procedures,
visit www.idealindustries.com
IDEAL INDUSTRIES, INC.
Becker Place, Sycamore, IL 60178, USA / 815-895-5181 • 800-435-0705 in USA
International offices:
Australia • Brazil • Canada • China • Germany • India • Mexico • UK
For complete sales office contact information, visit us at:
www.idealindustries.com
Form No. 6510-30-0400 Rev.F
©2006 IDEAL INDUSTRIES, INC.
®
LANTEK LAN Cable Testers
Quick Reference Guide
10/06
Printed in U.S.A.