HDS Systems EDC Tactical User Manual page 17

process takes roughly 12 hours before your flashlight is finally turned
off.
Each time the Automatic Turn Off feature dims your flashlight, you will
see a triple-blink.
If you are using a lower power setting, you will not see any change
until the dimming process has reached your brightness level. This
could be seconds, minutes or hours past the 10 minute start,
depending on the starting brightness level.
You can click the button at any time during the dimming sequence to
return your flashlight to the original brightness level and reset the
Automatic Turn Off timer for another 10 minutes.
Button Lockout – <triple-flash>
The Button Lock feature allows you to lock the button on your
flashlight to prevent it from accidentally turning on. When the Button
Lock feature is enabled and your flashlight is turned off, a triple-click
will toggle the button lock – i.e., unlocking the button if it is locked or
locking the button if it is unlocked.
Your flashlight will turn off when you lock the button and will turn on
when you unlock the button. When the button is locked and you press
the button, your flashlight will flash 3 times to indicate the button is
locked and then turn off.
Locator Flash – <dim flash>
The Locator Flash feature allows your flashlight to emit a short flash of
dim light every three seconds when turned off. The periodic short
flash makes it easier to find your flashlight in the dark.
When the Locator Flash feature is enabled and your flashlight is
turned off, a quad-click will toggle the locator flash on and off. The
default condition following a reset and after toggling the Locator Flash
feature is to turn on the locator flash when the feature is enabled and
off when the feature is disabled.
Pseudo Momentary – <long flash, short flash>
The Pseudo Momentary feature allows your flashlight to differentiate
between a click and a press-and-hold when your flashlight is turned
16