Prepare To Save Tests; Clean And Inspect All Connectors - Fluke DTX-CLT CertiFiber Getting Started Manual

Figure 1. Charging the Battery (left) and
B

Prepare to Save Tests

•
Check the memory space available:
Turn the rotary switch to SPECIAL FUNCTIONS; then select
Memory Status.
•
Select a cable ID source:
You can select IDs from a pre-generated list or create an ID after
each test. Turn the rotary switch to SETUP, select Instrument
Settings, select Cable ID Source; then select a source.
•
Set up a job folder:
On the Instrument Settings menu select Current Folder. Select
an existing folder or press
folder.
•
Enter job information:
On the Instrument Settings menu press
the Operator, Site, and Company names. To enter a new name,
select a setting, press
A D
finished.
C

Clean and Inspect All Connectors

When using the fiber modules, use proper procedures to
clean and inspect all fiber connectors before every use.
Neglecting this step or using improper procedures can cause
unreliable test results and may permanently damage the
connectors. See the Users Manual for instructions.
Removing the Battery (right)
J
J
Create; then use the softkeys,
H
, and for editing. Press
W
Caution
Create Folder to create a new
C
to show the tab with
N
gfa01.eps
BC
when you are