Telaire Ventostat 8000 Series User Instruction

TELjjlRE.
Installing the Sensor
Before performing service or maintenance operations on
the systems, turn OFF main power switches to the unit.
Electric shock can cause personal injury. Please read and
follow the wiring instructions precisely; miswiring may
cause permanent damage to the product.
Basic Installation for Non-Display Units
1. Separate the case into its front and rear sections.
2. Secure the rear section of the case to the wall or junction box using
the supplied screws, and make necessary wire connections.
3. Mount the Controller on the base by ali
securing to the bottom clips. Secure the Ventostat with the supplied
set screw. A one-minute stabilization warmup will take place.
Internal Label for Non-Display Units
uO uO
I > Q
Z� Z�
I > 0
-Jl
N
Ill
>ou >o u
_.
II) ...
�
(a)
0-10V
0-5 V
Jumper Settings for Non-Display (a) and Display (b)
Note: Example b shows outputs of CO
V, humidity- 4-20 mA, and active temperature
Amphenol
Advanced Sensors
!WARNING!
-
T£L/URE
ing the top clips and then
gn
STRIP GAUGE
-.J '4-
6mm/14"
5 J2 U"I
�
� l:!:!au
e::::::=
�
N
� ,o
a;
... a:
O
U"I
U"I ... � JU
J-Jl2 �
(b)
... > ..... >
Units
- 4-20 mA and CO
2
0-5 V.
-
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
(
Amphenol Advanced Sensors
6860 Cortona Dr. , Suite B
Goleta, CA 93117
www.amphenol-sensors.com
Basic Installation for Display Units
1. Separate the case into its front and rear sections.
2. Secure the rear section of the case to the wall or junction box using
the supplied screws, and make necessary wire connections.
3. Mount the Controller on the base by ali
securing to the bottom clips. Secure the Ventostat with the supplied
Output
set screw. A one-minute stabilization warmup will take place.
_ Jumper
4. When fitting the T8300 /T8400 (pitot tube version), complete the
elections
installation by screwing the tube connectors to the input ports on the
sensor. The tubing connectors can be attached to either input port. It
will not affect the perfonnance of the sensor. (See page 3 for fi.uther
instructions.)
0
:c
0-10
2 -
TestEquipmentDepot.com
T elaire Ventostat
Qt� a3
------
I
t.t
'rELJill
'rEl./dRE
ing the top clips and then
gn
Internal Label for Display Units
8000 Series
rM
CO2 Sensor
User Instructions
-------�
ga-1
Output
umper
Selections
T63216-008
September 2014
Page 1 of 4