Advertisement
Connection
and Description
Speakers Connection
The connection of the speakers to the
module is done using two JST VHR-2N
connectors provided. A cable should be
crimped to the terminals (1.25mm
section maximum) and placed on the
connector box, so that the metallic tab
fits into place.
The connection is as follows:
Front Panel Description
1
Signal Input: Female XLR Connector for signal input.
2
Signal Link: Male XLR Connector for signal link.
3
Ethernet Connectors: RJ45, two ports Ethernet switch.
4
USB Connector: B type USB connection.
5
LED ON:power supply ON. Blinking indicates StandBy mode.
LED SIGNAL: input signal presence indication.
LED LIMIT: lights when the DSP limiters are working.
LED CLIP: the maximum input or output has been reached.
6
Quick Preset: press the button for 3 seconds to change the
desired output preset.
ON: press SET1 button for 2s to turn on (in StandBy mode).
LEVEL: push SET 3-4 buttons simultaneously to enter LEVEL
mode (both LEDs light up). Then use 3 and 4 to change level.
7
Mains connection: inlet and outlet powerCON True1
connection. It works also as a main switch, as it is a connec-
tor with breaking capacity.
Verbindung und
Beschreibung
Lautsprecher Anschluss
Der Anschluss der Lautsprecher am
Modul erfolgt durch zwei JST VHR-2N
Stecker. Ein Kabel wird auf die
2
Anschlussstifte gecrimpt (maximal
1,25mm²) und ins Steckergehäuse
gesteckt, so dass der metallene Stift
einrastet.
Der Anschluss erfolgt wie folgt:
La conexión de los altavoces al modulo
se realiza a través de 2 conectores JST
VHR-2N suministrados. Debe de crim-
parse un cable a los terminales
(sección máxima de 1.25mm
ducir los mismos sobre la caja del
conector, de forma que la pestaña
metálica se aloje en su hueco.
El conexionado es el siguiente:
1
2
Conexión y
Descripción
Conexión de Altavoces
2
) e intro-
Optional Case
3
4
5
6
7
Advertisement
