Table of Contents
Advertisement
Installation
Screw in the mounting supports for the extractor
1.
hood until they are hand-tight, use a spirit level to
level the appliance and then screw the mounting
supports in fully.
Screw in the threaded bolt, leaving it protruding out
2.
of the wall by 5 - 9 mm.
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
Hanging the appliance
If there is any protective film on the appliance, first
1.
remove the protective film from the back and,
following installation, remove the rest of the film.
Remove the metal grease filter before hanging the
2.
appliance.
Hang the appliance on the wall.
3.
Firmly tighten the knurled nuts.
4.
Reinsert the metal grease filter and connect the
5.
power supply.
Installation en
13
Advertisement
Table of Contents
