Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Siemens LC8K950
Summary of Contents for Siemens LC8K950
- Page 1 Operating and installation instructions LC8K950...
- Page 2 Fig. 1 Abb. 1 ELECTRO mind. mind.
-
Page 3: Appliance Description
Operating Instructions Appliance description Operating modes Glass panel Chimney panelling This can be achieved if the combustion air is able to flow through non-lockable openings, e.g. in doors, windows and in conjunction with an air supply/air-intake wall Light / fan box or by other technical procedures such switches as reciprocal interlocking. -
Page 4: Before Using For The First Time
Before using for the first time Important notes: Safety instructions The Instructions for Use apply to several Do not flambé food directly under the versions of this appliance. Accordingly, extractor hood. you may find descriptions of individual Risk of grease filter catching fire due features that do not apply to your to flames. -
Page 5: Operating Procedure
Operating procedure Intensive setting: The most effective method of removing vapours produced during cooking is to: Maximum power is obtained at the intensive setting. It is only required for short Switch the ventilator ON intervals. as soon as you begin cooking. ç... -
Page 6: Filters And Maintenance
Filters and maintenance Removing the grease filter: Ausbauen der Fettfilter: 1. Pull the bottom of the most outer filter 3. Detach the safety cord behind the filter. until it comes away from the magnets. 2. Unhook the filter in a vertical position from the top. - Page 7 Filters and maintenance Inserting the grease filter: Ausbauen der Fettfilter: 1. Insert the inner filter at the back and fold 3. Hook in the outer filter in a vertical the filter upwards. position. 2. Attach the safety cord behind the filter. 4.
- Page 8 Filters and maintenance Grease filters: Cleaning the metal grease filters: In normal operation (1 to 2 hours daily), Metal filters are used to trap the greasy the metal grease filter must be cleaned element of the vapours that develop 1 x a month. during cooking.
-
Page 9: Cleaning And Care
Cleaning and care Isolate the extractor hood by pulling out Stainless steel surfaces: the mains plug or switching off the fuse. Use a mild non-abrasive stainless steel cleaner. Do not clean the extractor hood with Clean the surface in the same direction abrasive sponges or with cleaning agents as it has been ground and polished. -
Page 10: Replacing The Light Bulbs
Replacing the light bulbs 1. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. When switched on, the halogen bulbs become very hot. Even for some time after the bulbs have been switched off there is still a risk of burns. -
Page 11: Installation Instructions
Installation Instructions: Important information Additional information concerning gas Old appliances are not worthless cookers: rubbish. Valuable raw materials can be reclaimed by recycling old appliances. When installing gas hotplates, comply Before disposing of your old appliance, with the relevant national statutory render it unusable. -
Page 12: Prior To Installation
Prior to installation Exhaust-air mode The exhaust air is discharged upwards through a ventilation shaft or directly through the outside wall into the open. Exhaust air should neither be directed into a smoke or exhaust flue that is currently used for other purposes, nor into An air-intake/exhaust-air wall box by itself a shaft that is used for ventilating rooms in is no guarantee that the limiting value will... -
Page 13: Electrical Connection
Prior to installation Electrical connection Round pipes: If you fit your own plug, the colours of these wires may not correspond with the We recommend identifying marks on the plug terminals. Internal diameter: 150 mm (at least This is what you have to do: 120 mm). -
Page 14: Installation
Installation This extractor hood is intended to be 05. Screw on the upper and the two lower mounted onto the kitchen wall. fixing brackets. 01. Remove the grease filter (refer to Operating Instructions). 02. Draw a line on the wall from the ceiling to the lower edge of the hood at the centre of the location where the hood is going to be mounted. - Page 15 Installation 07. Screw in the lower bolt (hex bolt). 13. Carefully pull the upper flue duct upwards and screw the sides to the fixing bracket with 2 screws. 08. Connect up the air outlet pipe. 14. Fitting the glass panel: 09.
- Page 16 Family Line 01805-2223 3 0,12/min. DTAG Siemens-Hausgeräte Besuchen Sie uns im Internet: http://www.siemens.de/hausgeraete 9000 161 455 Siemens-Electrogeräte GmbH Printed in Germany 0306 Es.