Troy-Bilt Brushless DC Motor Driver User Manual page 11

Tr UBS Series Brushless DC Motor Driver User's Manual
After electrify the 「ALARM」light lit up, please contact to our local seller.
「ALARM」release：(1)「A.R.」input contact keep at the「L」condition 10ms then back to the「H」
Connecting the motor
●
The motor is connected to the driver using the connectors provided.Be sure the motor connector
is fully inserted to the driver connector. Please turn the 「POWER SW」OFF while connecting
which avoid the improper connection to cause the driver damaged.
The cable can be extended to a maximum of 10m using an extension cable (Sold
separately).Please choose the suitable extension cable while ordering.
The total length from motor to driver＝Motor lead length 45cm+Extension cable length
Model of extension cable
CB-010
CB-020
CB-030
CB-050
CB-100
※Actual cable length = Required length + 10cm
Connecting the AC Power
●
The CE and UL certified terminal board shall be used for the power input. When connecting the
driver, fix the power supply wire at the terminal (4-pin accessory) and then insert the terminal into
the power terminal jack on the driver. Use AWG18 power source cable (in profile over 0.75mm
The driver power ground (FG) terminal should be connected with Class 3 grounding. Use as
short grounding wires as possible (The ground impedance should be less than 100Ω).
2200
2000
1800
1600
1400
1200
1000
800
600
400
200
0
Resistance 0 1 1.5
電阻值(k
(KΩ)
Ω )
0 5 10
condition.
(2)Please turn the「POWER SW」OFF more than 5SEC then input the power
Length(m)
Speed potentiometer graduation－Speed(RPM)
速度設定器刻度 - 轉速 變化曲線
2.0 2.6 3.5 5.1 6.1
15 20 25 30 35
1
2
3
5
10
7.5 8.5 9.9 11.3 12.9 14.2
40 45 50 55 60
速度設定器刻度
9
延長電纜線
Extension cable
15.5 16.5 17.4 18.5 19.2
65 70 75 80 85
2
).
19.5 20
90 95 100
UBS-VI-V08E