Phonic Ear FTS01 Quick Start Installation Manual

Quick star t installation guide for an induction loop
1
system components
Amplifier
teleloop
cable clips
Package may vary depending on product and model
3
Pull up a section of the carpet along the
baseboard with the needlenose pliers
6
Pull the fishtape up and double knot the
teleloop cable through the open slot
9
Stretch the cable along the baseboard
and tuck it in with the screwdriver
International +45 3917 7101
© 2005 Phonic Ear Inc. Phonic Ear and the names of Phonic Ear products are trademarks or registered trademarks of Phonic Ear Inc. in the U.S. and other countries.
power
transformer
teleloop cable
4
7
10
please refer to product user guide for complete user instructions
2
installation tools
T-25 staples
Gather these tools before you begin installation
Insert a flathead screwdriver to lift
the carpet away from the baseboard
Now pull the attached teleloop cable
back under the carpet to the other side
Tack in the cable clips or use a staple
gun to secure points along the way
jeweler's flathead
screwdriver
staple gun
wire strippers
fish tape
needle nose
(not essential)
pliers
flathead
screwdriver
5
Guide the fishtape under the carpet
toward the other side of the room
8 Untie the knotted teleloop cable
from the fishtape
11 Around doorways without carpet, staple
the cable at the bottom and pull taut
Continued on the back side
921-34-210-00 Rev. C 1005