To Attach and Remove the Hood
•
Push each end of the hood into the
plastic holders located on either side of
the seat frame.
•
Attach press studs of hood onto stud on
hood ratchet.
•
To remove hood, squeeze small clips on
both hood ends so hood can pull out
through the plastic holders.
To Attach Bumper Bar
•
Slide each end of the bumper bar into the
plastic holders located on either side of
the seat frame.
Warning: Do not use the bumber bar as
a carry handle.
To adjust angle of seat
•
Press top oval silver buttons on both sides
of stroller frame simutaneously and adjust
to desired angle.
To Attach Bootcover
•
Place bootcover over stroller and
attach studs to the side of the hood.
www.childcareproducts.com.au
8
•
Place mattress into seat.
•
Feed crotch strap through the bottom hole of
the mattress, and pull through waist straps
from side of mattress.
•
The shoulder straps are to be placed under the
mattress.
Warning: To avoid strangulation hazard, the over
shoulder harness must be properly hidden
beneath the mattress.
To Attach and Remove the Hood
•
Push each end of the hood into the plastic
holders located on either side of the seat frame.
•
Attach press studs of hood onto stud on hood
ratchet.
•
To remove hood, squeeze small clips on both
hood ends so hood can pull out through the
plastic holders.
To Attach Bootcover
•
Place bootcover over bassinet and attach studs
to the side of the hood.
www.childcareproducts.com.au
5