Sz (Rfid) Tape - Brother P-Touch RL-700S User Manual

SZ (RFID) Tape

• TZ and HG tapes can be set their label length up to 4" (100 mm) but SZ tape can be set its
label length from 2.14" (53.5 mm) to 4" (100 mm) with P-touch Editor or the printer driver. Also,
note that the portion after the specified length up to the next label will be blank.
• On SZ tape, a number in the format xx/30 is printed in the leading margin of labels. (xx is a
number in the range 2-30.) This number indicates what label it is among the 30 RFID tags in
the cassette.
When all 30 labels are used, END will be printed on the label. Replace it with the new cassette.
• RFID tags are in the leading portion of labels printed on SZ tape. Avoid cutting or damaging
this portion, which may impair or disable the RFID tag.
Amount Used
At least 2.14" (53.5 mm)
Half-Cut
• If ERROR is printed in the trailing portion of a label, an error occurred when writing data to the
RFID tag. Make sure no reader/writers or other devices interfering with access to the RFID
tags and try printing again.
Half-Cut
• To avoid damaging cassettes and preventing further use, do not pull out the tape.
• To avoid rendering data unreadable, do not apply labels to metal objects, electronic devices,
or other RFID tags.
Up to 4" (100 mm)
RFID Tag
Print Data
ERROR
Before Use
9