Replacing The Rear Turn Signal Light Bulb; Troubleshooting - Yamaha T115FL-2P Owner's Manual

Replacing the rear turn signal
light bulb
1. Remove panel B. (See page 7-7.)
2. Remove the socket (together with
the bulb) by turning it counter-
clockwise.
3. Remove the burnt out bulb by
pulling it out.
4. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
NOTICE
If a taillight bulb of different wattage
than recommended is used, it may
cause the battery to discharge or af-
fect the taillight lighting.
Periodic maintenance and adjustment
EAUU2052 5. Install the socket (together with
the bulb) by turning it clockwise.
6. Install the panel.
ECAU0091

Troubleshooting

Although Yamaha motorcycles receive
a thorough inspection before shipment
from the factory, trouble may occur
during operation. Any problem in the
fuel, compression, or ignition systems,
for example, can cause poor starting
and loss of power.
The following troubleshooting chart
represents a quick and easy procedure
for checking these vital systems your-
self. However, should your motorcycle
require any repair, take it to a Yamaha
dealer, whose skilled technicians have
the necessary tools, experience, and
know-how to service the motorcycle
properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look
like Yamaha parts, but they are often
inferior, have a shorter service life and
can lead to expensive repair bills.
When checking the fuel system, do
not smoke, and make sure there are
no open flames or sparks in the ar-
ea, including pilot lights from water
7-30
WARNING
EAU25853
7
EWA15142