Table of Contents
Advertisement
W&T
the radio button DHCP and then click on the Continue
button.
•
Activating using Web Based Management
In the menu Config r Device r Basic Settings r Network
select the option Static. After entering the new IP address
and the valid subnet mask and gateway address, click on
the Apply button. To save the new setting in the USB-Ser-
ver, select Logout and Save. The device can now be reached
under the new IP address.
1
Switching from Static to DHCP mode causes the
device to revert from the static set IP address to the
factory default setting 190.107.233.110. If the IP
assignment using DHCP fails, for example because no DHCP
server is available, the USB-Server may no longer be
reachable, especially in routed network environments.
Reactivating Static mode using WuTIlity can only be done
using a computer in the same physical network.
3.2.2 Deactivating DHCP mode
DHCP mode is deactivated by switching from DHCP mode to
Static mode using WuTility or Web-Based-Management on the
USB-Server. In both cases the new values for IP address, subnet
mask and gateway address must be manually specified.
•
Deactivating using the WuTility management tool
From the device list select the desired USB-Server and click
on the IP Address button. In the resulting dialog window
activate the Static radio button. After entering the new IP
address and the valid subnet mask and gateway address
click on the Continue button..
•
Activating using Web Based Management
In the menu Config r Device r Basic Settings r Network
activate the Static option. After entering the new IP address
as well as the valid subnet mask and gateway address click
22
Assigning/Changing IP Parameters
i
Each IP address must
be unique within the
network.
Advertisement
Table of Contents
