Energizer 50806 User Manual page 7

HOW TO JUMP START YOUR VEHICLE
Please note that to jump start a vehicle at least 2 of the
4 blue power LED's (L) must be illuminated.
1. Plug the blue connector into the 12V jump starter
port (D), the LED (C) will flash green.
2. Connect the red clamp (A) to the positive '+', of the
vehicle's battery and the black clamp (A1) to the
negative '-'. If connected correctly the LED (C) will
show steady green. If the LED (C) shows red then
the clamps have been connected incorrectly.
Remove and start again. If you are sure that the
clamps are connected correctly but still the LED (C)
shows red, remove the red clamp and re-connect to
reset.
3. Only when the LED (C) shows steady green should
you start the vehicle.
4. Dependent on your vehicle's battery status you may
need to turn the ignition 2-3 times for the jump
7