Advertisement
HOW TO JUMP START YOUR VEHICLE
Please note that to jump start a vehicle the 'Battery
Power' percentage needs to be above 50%.
1. Plug the blue connector into the 12V jump starter
port (J), the LED (G) will flash green.
2. Connect the red clamp (F) to the positive '+', of the
vehicle's battery and the black clamp (F1) to the
negative '-'. If connected correctly the LED (G) will
show steady green. If the LED shows red then the
clamps have been connected incorrectly. Remove
and start again. If you are sure that the clamps are
connected correctly but still the LED shows red,
remove the red clamp and re-connect to reset.
3. Only when the LED (G) shows steady green should
you start the vehicle.
4. Dependent on your vehicle's battery status you may
need to turn the ignition 2-3 times for the jump
starter to operate. This isn't a fault, it is just the jump
starter analysing the vehicle's battery condition for it
to work effectively.
10
Advertisement
