Advertisement
Figure 3
Make sure
the ruler is to
this side
• Orient the folding leg assemblies into the crank
assembly with the lower end of the brace on the
crank side.
• From the outside, insert bolts with one washer through
crank assembly and leg assembly and then on the
inside secure with the other washer and lock nut.
Tighten all hardware.
• Assemble the rubber feet to the legs. Each foot has
a long side. Assemble the long side to the outside of
the leg.
Figure 4
Long side
Rubber
to outside
Foot
Folding Leg
Assemby
Bolt
Washer
Washer
• Turn the stand over and press down the folding lock bar
to lock the legs in place.
• The bench dogs may now be assembled into any of the
holes on the table top. The bench dogs can be moved
when needed to aid in clamping the workpiece.
• Slots in the crossbars are for on board tool storage.
ASSEMBLY
Wood
Notches to
Screws
inside
Crank
Assembly
Crank
Lower end of
brace to the
crank side
Crank
Assemby
Nut
Figure 5
Lock
Bar
• To fold the stand for storage, pull up on the folding lock
bar and press the front and back of the stand together.
Figure 6
Â
¬
WARNING
Keep the stand dry, clean, and free from oil and grease.
Always use a clean cloth when cleaning. Never use brake
fluids, gasoline, petroleum based products or any strong
solvent to clean the miter saw stand . Chemicals can
damage, weaken or destroy plastic which may result in
serious personal injury.
3
Bench Dog
Lock
Bar
Á
Â
3
Advertisement
