Advertisement
ETC Setup Guide
Cobalt Light Server
Hardware Setup
Connect Cables
Hard Power Switch
IEC Receptacle
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Step 7:
Note:
Cobalt Light Server
USB Ports x4
Display
Ports x3
Attach the appropriate IEC power cord to the power connector, then to the IEC receptacle.
Connect any monitors to the proper ports on the back of the Light Server.
Cobalt Light Server supports up to 3 monitors
using the following combinations:
Signal
Type
Display Port
Physical
Port
Display Port
Yes
Single/Multitouch monitors need to be
Windows 7 or 8 Compatible.
Displays using an active adapter have a maximum resolution
of 1920x1200.
Connect the USB mouse and keyboard to the USB connectors.
Attach a network ethernet cable to an ethernet port.
Connect optional cables as desired including remote trigger, MIDI, DMX512/RDM, and
phone remote.
When all connections are made, switch the hard power switch on.
Press the soft power switch, on the front of the unit, to power up the Light Server.
If the unit does not power up, check the rear panel to ensure the hard power switch
is on.
Ethernet
Ports 1 & 2
Audio Ports
(Audio In Not
Currently
Enabled)
DVI
VGA
Yes
Yes
with Active
with Adapter
Adapter
Page 2 of 3
Phone
DMX512/RDM
Remote
Ports x2
Remote
MIDI In
Trigger
& Out
Electronic Theatre Controls, Inc.
Advertisement
