Table of Contents
Advertisement
4.2. Back Panel Connections and Controls
7
7. X Signal Conditioned Output.
8. Y Signal Conditioned Output.
9. Z Signal Conditioned Output.
The three BNC connectors carry the conditioned analogue output voltages. The conditioned
outputs are the magnetometer X, Y and Z signals after they have been modified by the low/high
pass filters and, if a balanced output magnetometer is connected, converted to single-ended
signals.
10. Space for unique serial number.
11. Magnetometer socket for the connection of the magnetometer cable.
Note: Ensure correct orientation of the connector (indicated by the cut-out on the
connector body aligning with the notch in the socket).
BARTINGTON INSTRUMENTS
8
11
Figure 2. PSU1 Back Panel
Page 6 of 18
9
10
OM2443/4
Advertisement
Table of Contents
