Advertisement
•
Do not use a battery charger other than what is
specified for operation with the battery pack.
•
Look at the plus (+) and minus (-) marks on the
battery pack and product to make sure of correct
operation.
•
Do not use a battery pack not made for operation
with the product.
•
Do not mix battery packs of a different voltage or
manufacturer in a device.
•
Keep battery packs away from children.
•
Always purchase the correct battery packs for
the product.
•
Keep batteries clean and dry.
•
Clean the battery pack terminals with a clean dry
cloth if they become dirty.
•
Secondary battery packs must be charged before
use. Always use the correct battery charger and
WARNING: Read the safety chapter
before you assemble the product.
To remove the product from the
carton
1. Remove loose parts included with the product.
2. Cut down the two end corners of the carton and
put the end panel down flat.
3. Remove all package materials.
4. Remove the product from the carton and make
sure no loose parts are left in the carton.
To set the operation position
1. Lift the lower handle section to operation
position.
2. Install the supplied carriage bolts in the handle
and through the handle brackets. Tighten the
nuts with a 1/2 in wrench.
3. Lift the upper handle section into position on the
lower handle and tighten the two top knobs.
6
refer to the manual for correct charging
instructions.
•
Do not keep a battery pack on continuous charge
when not in operation.
•
Save the manual to refer to it in the future.
•
Only use the battery pack for its necessary
operation.
•
Remove the battery pack from the product when
not in operation.
•
Keep the battery pack away from paper clips,
keys, nails, screws, or other small metal objects
while in operation. This can make a connection
between terminals. Shorting the battery pack
terminals together can cause burns or a fire.
ASSEMBLY
4. Discard all remaining package material from the
motor control handle.
To set the product in transport
position
1. Loosen the two handle knobs on the upper
handle. Let the handle fold down to the rear.
2. Remove the carriage bolts and nuts that attach
the lower handles to the handle brackets.
3. Pivot the full handle assembly forward and let it
become stable on the handle brackets.
To assemble the grass catcher
1. Attach the grass catcher frame to the grass bag
with the rigid part of the bag on the bottom. Keep
the handle of the frame out of the top of the bag.
355 - 002 - 03.10.2017
Advertisement
