Advertisement
ELECTRICAL CONNECTIONS
LOCAL AUTHORITY REQUIREMENTS
Installation is only permitted by an authorised person, and carried out according to instructions provided by the
manufacturer. Incorrect installation might cause harm and damage which the manufacturer accepts no
responsibility. The electrical connection can be found at the bottom of the appliance, rear left hand side (looking
from the front).
INSTALLATION
This cooktop must be connected to a 220-240V 50Hz power supply. It is earthed via the cord.
Before carrying out the connection to the power supply, the voltage rating of the appliance (stamped on the
appliance identification plate) must be checked for correspondence to the available mains supply voltage, and the
mains electric wiring should be capable of handling the hob's power rating (also indicated on the identification
plate);
The power point must be connected to a suitable earth wiring, in conformity to current safety regulations.
Ensure that the power supply is within 900 mm of the cooktop. The power supply cord must not touch against
any hot surfaces and must be placed so that its temperature does not exceed 75ºC at any point along its length.
The colours of the wires in the hob power cable may not correspond with the colours marked on the terminals of
your electrical plug .The plug should in any case be wired as follows:
- Connect the green/yellow wire to the terminal marked with the letter E or the earth symbol or coloured
green/yellow;
- Connect the blue wire to the terminal marked with the letter N or coloured black;
- Connect the brown wire to the terminal marked with the letter L or coloured red.
After having installed the appliance, the power switch or power plug must always be in an accessible position.
Electrical connection diagrams
N.B For connections to the mains power supply, never use adapters, reductions or multiple power points as
these may overheat and catch fire.
In the event that installation should require modifications to the mains supply wiring system or if the power plug is
not suitable for the type of power point available, it is required that a qualified technician be called to carry out
substitution.
The technician will also have to verify that the cross-section of the electric cables on the power point match the
appliance's power rating.
9
Hide quick links:
Advertisement
