Advertisement
OPERATING INSTRUCTIONS
IGNITING THE BURNERS
The knob on your gas cooktop controls both ignition and the gas supply. Proceed as follows to ignite
the burners:
Press down and turn the control knob for the burner you would like to use anti-clockwise. As the knob
reaches 90º C (MAX and ignition), the electronic ignition will start sparking at the burner. Hold the
control knob down for 3 to 5 seconds so the thermoelectric safety system can engage and then release
the control knob. The flame can now be adjusted by turning the control knob anti-clockwise until it
reaches the desired size. Only adjust the knob between the MAX and MIN settings, otherwise the
burner will turn off.
To turn off the burner, rotate the control knob clockwise to the 'Off' position (straight up).
NOTE: If the burner does not light within 12-15 seconds, turn the control knob back to the 'Off'
position, and attempt re-ignition after 1 minute. This will allow any unburned gas to escape from the
burner area.
If the burner does not light, firstly check that the cooktop is connected to electricity. If connected ensure
that the gas is turned on and that the electrodes are sparking. Also ensure that all parts of the burner
are correctly positioned.
USING THE BURNERS
For greater efficiency and less gas consumption, use pots and pans with the right diameters for the
burners. Avoid having flames extending out from underneath the pans (refer to the table in the
appliance details section for recommended sizing).
When cooking, always try to use a pot or pan with a flat base. Pots and pans with an uneven or curved
base will cause the burner to run inefficiently and will take longer to cook your food.
Always heat the water to boiling point before placing food items to be cooked. After the water has
boiled, the heat setting can be dropped to maintain the desired cooking temperature. This will speed up
the cooking time and is more efficient.
In the event of a power outage, your gas cooktop can still be used. Press and turn the desired knob to
the 'high' position and light with a match. Depress the knob after approx 3 seconds and continue to
operate the burner.
AUTOMATIC SAFETY VALVES
This safety device automatically closes the gas valve if there is any disruption of the gas flow to the
appliance, or if the gas flame goes out.
13
Hide quick links:
Advertisement
