Challenge HTJ-2027 Instruction Manual page 4

1. Remove the white fog nozzle (1) from the top of the blue water tank. Never
remove or fill the water tank with the fog nozzle attached.
2. Remove the blue water tank from its base, and turn the tank upside-down.
3. Unscrew the filler cap with filter in the direction shown, and remove.
Take off the nozzle Lift off water tank Turn over, unscrew the cap
4. Fill from the tap or distilled water container to the top of upturned tank or as
much as required
5. Replace filler cap/filter assembly.
Fill (tap or Jug) Fasten the cap Fit tank to base as align marks
Align marks
6. Turn the tank over and wipe away any spilt water, carefully fit the tank onto the
base, taking care to align correctly noting the alignment marks on the base unit
and tank.
7. Refit fog nozzle (1)
8. Plug in to a 220-240V~50/60Hz, wall socket, and switch on with units main
power switch (5)
Note: If the indicator light is Red, water is still filling the flume (in the base
unit), wait until it turns Blue, the unit will start working.