Dynamix 10/100/1000 (SFP) User Manual

6. Application Diagram
Troubleshooting
7.
Diagnosing Media Converter Indicators
Dynamix Media Converter can be easily
monitored through its comprehensive panel
indicators. These indicators assist in
identifying problems the Media Converter
may encounter. This section describes
common problems you may encounter and
possible solutions
1. Symptom: POWER indicator does not
light up (green) after power on.
Cause: Defective External power supply
Solution: Check the power plug by plugging
in another that is functioning properly. Check
the power cord with another device. If these
measures fail to resolve the problem, have
the unit power supply replaced by a qualified
distributor.
2. Symptom: Link indicator does not light up
(green) after making a connection.
Cause: Network interface (ex. a network adapter
card on the attached device), network cable, or
switch port is defective.
Solution: 2.1 Verify if both of the switch and
attached device are powered on.
2.2 Be sure the cable is plugged into both the
switch and corresponding device.
2.3 Verify that the proper cable type is used and its
length does not exceed specified limits.
2.4 Check the Adapter on the attached device and
cable connections for possible defects.
2.5 Replace the defective Adapter or cable if
necessary.
8. Compliance and Safety Information
FCC Warning
This equipment has been tested to comply with the
regulations for a Class A digital device, pursuant to
Part 15 of the FCC Rules.
These regulations are designed to provide
reasonable protection against harmful interference
when the equipment is operated in a
commercial environment. This equipment can
generate, use, and radiate radio frequency energy
and, if not installed and used in accordance with
the instruction manual, may cause harmful
interference to radio communications. Operation of
this equipment in a residential area is likely to
cause harmful interference in which case the user
will be required to correct the interference at
his/herown expense.
CE Mark Warning
This is a CE class A product. In a domestic
environment, this product may cause radio
interference in which case the user may be
required to take adequate measures.
www.godynamix.com
Dynamix 10/100/1000 (SFP)
Media Converter
User Manual
V. 1.2