Bosch 1 270 020 906 Owner's Manual page 10

English–9
Switching the Walk Assistance On/Off
The walk assistance can make it easier for you to push the
eBike. The speed of this function depends on the selected
gear and can reach a maximum of 3.7 mph. The lower the
selected gear, the lower the speed of the walk assistance
function (at full capacity).
 Using the walk assistance function is only recom-
mended when pushing the eBike. There is risk of injury
if the wheels of the eBike are not in contact with the
ground while using the walk assistance.
To activate the walk assistance function, briefly press but-
ton "WALK" on your on-board computer. After activation,
press button "+" within 3 s and keep it pressed. The eBike
drive is switched on.
Note: The walk assistance cannot be activated in the "OFF"
assistance level.
The walk assistance is switched off as soon as one of the
following occurs:
– you release the button "+" 13,
– the wheels of the eBike are stopped (e.g. by actuating
the brakes or impacting against an obstacle),
– the speed exceeds 3.7 mph.
Note: On some systems the walk assistance function can
be started directly by pressing the "WALK" button.
Speed and Distance Indicator
The speed indicator f always displays the current speed.
The following functions are available in the function indica-
tor (combination of text indicator d and value indicator e):
– "Clock": Current time
– "Max. speed": Maximum speed achieved since the last
reset
– "Avg. speed": Average speed achieved since the last
reset
– "Trip time": Trip time since the last reset
– "Range": Estimated range of the available battery pack
charge (for constant conditions such as assistance lev-
el, route profile, etc.)
– "Odometer": Display of the total distance traveled with
the eBike (cannot be reset)
1 270 U20 XBI | (20.4.16)
– " NuVinci Cadence/Gear": This menu item is dis-
played only in conjunction with a Nu Vinci H|Sync auto-
matic transmission.
If you press the "i" button for longer than 1 s, you will ac-
cess the NuVinci menu item from any menu item in the
information menu.
To switch from the " NuVinci Cadence" mode to the
" NuVinci Gear" mode, press the "i" button for 1 s.
To switch from the " NuVinci Gear" mode to the
" NuVinci Cadence" mode, all you have to do is brief-
ly press the "i" button.
The default setting is " NuVinci Cadence".
Range
– "Gear": This menu item appears only in conjunction
with a Shimano-Di2 gear hub. The currently engaged
gear of the transmission is shown on the display. The
newly engaged gear will be shown briefly on the display
whenever the gear is shifted.
– " Autom. Gear Selection": This menu item appears
only in conjunction with an SRAM automatic transmis-
sion.
Range
By pressing the "i" button for more than 1 s, you can
switch back and forth between the " Autom. Gear
Selection" automatic mode and the " Gear" manual
mode.
If you are in first gear in manual mode, you can also
press the "–" 12 button to go to the " Autom. Gear
Selection" mode. By pressing the "–" 12 button again,
you can switch back to the manual mode. It is also pos-
sible to access the manual mode by pressing the "+" 13
button.
– "Trip distance": Distance covered since the last reset
Odometer NuVinci Cadence
(1 s)
(1 s)
NuVinci Gear
Odometer Gear: Auto
(1 s)
(1 s)
Gear
Bosch eBike Systems
(1 s)