Page 6
EN - Instruction on mounting and use WARNING! Do not connect the appliance to the mains until Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, damages or the installation is fully complete. fires caused by not complying with the instructions in this With regards to the technical and safety measures to be adopted for fume discharging it is important to closely follow manual, is declined.
correct use in order to reduce the environmental impact: Electrical connection Switch ON the hood at minimum speed when you start The mains power supply must correspond to the rating cooking and kept it running for few minutes after cooking is indicated on the plate situated inside the hood.
Page 8
Fig. 10 Fig. 4 12. Join the two upper sections of the duct covering the Adjust extension of the hood support structure, as the final height of the hood depends on this. perforated frame. Note: In some cases the upper section of the lattice is Fix each individual section in place using 2 screws (1 per fixed to the lower section with one or more screws, side) near the ceiling.
Description of the hood Hood in stand-by: LED LIGHT SWITCHED OFF Fig. 1 1 st suction speed (power) -GREEN LED LIGHT 1. Control panel 2 nd suction speed (power) – ORANGE LED LIGHT (amber) 2. Grease filter 3 rd suction speed (power) - RED LED LIGHT 3.
Page 10
Coal filter saturation signal disactivaction (for particular applications) Switch off hood (see above paragraph “suction speed (power) selection”). Press and hold down (for more than 5 seconds) the T1 button on the control panel, the LED light will start flashing GREEN indicating that the coal filter saturation signal has been disactivated.
Page 11
Remote control Warning! Some functions of this remote control may only be activated with certain hood models. Remote control affiliation: Keep T2 +T5 pressed within the first minute the hood is powered. Once pairing is complete it is displayed on the hood. Description of the remote control functions T1.
Therefore, we recommend observing these instructions. Maintenance of the remote control The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate Cleaning the remote control: maintenance or failure to observe the above safety Clean the remote control with a damp cloth and a neutral recommendations.
Need help?
Do you have a question about the CHROME EDS IX/A/85 and is the answer not in the manual?
Questions and answers