Platinum PT-TTRP22 Quick Setup Manual

PT-T TRP22
22" TABLETOP TRIPOD
QUICK SETUP GUIDE
Before using your new product,
please read these instructions to prevent any damage.

PACKAGE CONTENTS

• Tripod
• Carrying case
• Quick Setup Guide

FEATURES

• Small, tabletop size
• Supports most cameras or camcorders up to 3.3 lbs (1.5 kg)
• Supports low-angle shooting at 8" (20.3 cm) height
• Adjustable center column for quick height adjustment
• 11" (28 cm) folded length and carrying bag for portability
• Quick-flip leg locks for quick and easy setup
• Extendable leg braces for extreme low-angle macro shooting
• Light-weight and durable aluminum legs
• 3-way pan head for precise setting and smooth video
• Panoramic angles: 360° horizontal and 90° vertical
• No-slip rubber feet for stability
# ITEM DESCRIPTION
1 Side-tilt locking knob Locks the side-tilt base plate.
2 Quick-release Locks the quick-release plate to the mounting base plate.
mounting plate
locking lever
3 Tilt locking handle Adjusts and locks the pan head so it will not tilt.
Secure your camera or camcorder to the quick-release mounting
4 Mounting screw
plate with this screw.
5 Quick-release Mount your camera or camcorder to this removable plate.
mounting plate
6 Mounting base plate
Slide the quick-release mounting plate into this base plate.
7 Pan locking knob
Locks the horizontal movement of the head.
8 Center column stopper Locks center column movement.
knob
9 Center column Provides quick height adjustment.
10 Slide brace
Individually adjusts leg angles.
11 Leg lever Provides quick leg adjustment.
12 Rubber foot Provides a secure, non-slip footing for your tripod.

SETTING UP YOUR TRIPOD

1 Flip the leg levers (two / leg) on each leg open, extend the legs to the length
you want, then close the levers to lock the legs in place.
Caution: Incorrectly securing a leg lever can cause the tripod leg to retract
unexpectedly and could result in damage to the tripod or to the attached
camera or camcorder.
Leg lever
2 To adjust the height of the center column, loosen the center column stopper
knob, raise the center column to the height you want, then tighten the stopper
knob.
3 To set the angle position of a leg, press in on the tabs on the sides of the slide
brace, then pull the leg out. To put the leg back in the standard position, push
the leg back into the brace until the tabs lock into place.
Slide brace
Tab