Installation; Channel Settings - Toshiba 32LV703R Service Manual

INSTALLATION

Channel Settings

Initial setup
The first time user switches on TV set, "initial setup" wizard will be shown in OSD menu to
guide user to start channel scanning. The "channel scanning" takes several minutes. To stop
the scanning, press the "EXIT" key.
1. Select your language
2. Select your country
3. Start scanning
"Channel scanning", "Analog channels: found channel no." and status will be shown in
OSD menu during scanning.
Channel scan (on TV mode)
1. Select "country": Press "MENU" on the remote control. Then select "Set up" →
"Country" → your country in OSD.
2. Start scanning: Press "MENU" on the remote control. Then select "Set up" → "Auto
tuning" to start scanning.
When channel scanning finished, press "EXIT" key to leave OSD menu.
The found analog programs will be numbered in ascending order starting from 0.
Analog manual store
Press "MENU" on the remote control. Then select "Set up" → "Manual tuning" to start
manual scanning from user specified frequency. Once new program is found, user can store
this new program to a new program number.
Channel skip
1. Press "MENU" on the remote control. Then select "Set up" → "Manual tuning", then
follow OSD indication to select Channel skip.
2. Use up / down key to select the program you want to skip. Then press "OK" key. A
"tick" symbol will be show in right side box.