1. Manuals
  2. Brands
  3. Lightforce Manuals
  4. Automobile Accessories
  5. Striker
  6. User instructions

Lightforce Striker User Instructions

Led driving lights
Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

USER INSTRUCTIONS
S T R I K E R L E D
U S E R I N S T R U C T I O N S
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Striker and is the answer not in the manual?

Questions and answers

Related Manuals for Lightforce Striker

Summary of Contents for Lightforce Striker

  • Page 1 USER INSTRUCTIONS S T R I K E R L E D U S E R I N S T R U C T I O N S...

  • Page 2: Fastener Torque Specifications

    DIY TWIN PACK WITH TOOLS AND CONSUMABLES INSTALLATION KIT CONTENTS REQUIRED • 2 x Striker LED driving lights • Spanner to access battery terminals • 2 x Spot filters • Ratchet with 3 inch extension • 2 x Reversible mount and hardware •...

  • Page 3: Technical Specifications

    STRIKER LED INSTALLATION INSTRUCTIONS TECHNICAL SPECIFICATIONS GENERAL CARE AND SAFETY TIPS • Power: 60 Watts • Distance to 1 lux (pair): 754m To wash your lights, use plenty of warm soapy water and a soft cloth only (this • Distance to 1 lux (single): 533m prevents surfaces from marking).
  • Page 4 STRIKER LED INSTALLATION INSTRUCTIONS Fig 1. Driving Light Harness 1. 40 amp Relay 2. Insulated sleeved wires 3. Battery connector (negative) 4. Battery connector (positive) 5. 15 amp fuse 6. Driving light connectors 7. High beam pickup wire with bullet terminal (negative) 8.
  • Page 5 Fig 5. H4 patch harness 3. Route the insulated sleeved wires that run Green from the relay to the driving light connectors to each of your installed Striker LED Headlight Driving Lights and connect the driving light connector connectors to the back of each light. Ensure...

  • Page 6: Front View

    STRIKER LED INSTALLATION INSTRUCTIONS STEP 4. INSTALL THE DASH SWITCH STEP 6. CONNECT TO THE BATTERY 1. Find a suitable place on the dash to mount 1. Connect the ring on the red wired battery the dash switch. connector to the positive battery terminal using a spanner 2.
  • Page 7 2 pin Nut Socket waterproof connector. The 2 pin waterproof connector allows the single Striker LED to be wired into a Lightforce Driving Light Harness. Please consult the user instructions provided with the single Striker LED for more information...
  • Page 8 International Telephone: +61 8 8440 0888 | Fax: +61 8 8346 0504 All logos and images are subject to relevant trademark and copyright protection Lightforce Pty Ltd. Copyright © 2018. Data and specifications contained maybe subject to change without notice. Lightforce Australia Pty Ltd shall not be liable for damage, malfunction, failure resulting from accident, misuse, misapplication, unauthorised repair, neglect, modification, unauthorised or non standard replacement parts, accessories, bulbs, batteries or voltage or operation of the product beyond its technical and or environmental specification .

Table of Contents