LECAI Science And Technology LC Easyjet-16W Reference Manual page 60

7. Raster
8. Ink
1.Calibration
2.Feeding system
Print pass line 3.Printhead status
4.X motor belt
1.Calibration
2.Image size
Print size not 3.Maintop software
correct 4.Raster
5.X motor belt
6.Feeding system
1.Print head
2.Working Environment
3.Voltage
Print ink-break 4.Ink tube
5.ink Cartridge
6.Damper
7.Ink
8.Carriage board
Printing but 1.Printhead cable
print nothing 2.Carriage board
(not ink come 3.Printhead
out)
1.Heater switch
Heating but no 2.Heater cable
response 3. Temperature controller
4. Heater
1. Feeding unit
Media skew 2. Media
during printing 3. Pinch roller

Zhengzhou LECAI Science And Technology Co., Ltd.
 Hotline：
400-717-6789
 Te
l： 86-371-67896626
 Fax：86-371-67897386
 E-mail：lecai@locor.com.cn
 Website：http://www.locor.com.cn/
 Factory Address：B9, 2 Nanshan Industrial Zone, Yantian, Fenggang, Dongguan, Guangdong, China
Address：B1101, Torch Building, No. 8, Guohuai Street, High-Tech Zone, Zhengzhou, Henan, China
LC Easyjet-16W/18S User Manual V13GZ.1
6. Reduce carriage speed.
7. Clean the raster.
8. Please use LECAI original Ink.
1. Step calibration.
2. Feeding unit too tight, media can't feeding automatic.
3. Clean the print head.
4. Adjust the X motor belt tensioning.
5. Open "Eclosion" function.
1. Calibration the printer.
2. Check the Image size.
3. Re-install the Maintop software.
4. Clean the Raster.
5. Adjust the X motor belt tensioning.
6. Feeding unit too tight, media can't feeding automatic.
1. Clean Print head.
2.Temperature：18°- 35°Humidity：35RH - 65RH.
3. Use UPS.
4. Check whether the ink tube air leakage or folded.
5. Check whether the air hole of ink cartridge blocking.
6. Suck the ink to the damper or change the damper.
7. Please use LECAI original Ink.
8. Change the Carriage board.
1. Make sure the printhead cable correct connection
2. Change the printhead cable.
3. Change the carriage board.
4. Change the printhead.
1. Check whether the heater switch damage.
2. Check whether the heater cable looser.
3. Increase temperature from temperature controller.
4. Change the temperature controller.
5. Change the heater.
1. Check whether the feeding unit is smoothly.
2. Loading the media again and set the correct position.
3. Check whether all the pinch roller grip the media.
60