Thermo Scientific V.22/212A User Manual page 27

ATXn The Result Code Command sets which verbose/numeric result codes are to be
displayed. The "n" options are defined as follows:
0
1
2
3
4
ATYx The Enable Long Space Disconnect Command disables the long space disconnect
when the value of "x" is set to 0. An "x" value of 1 enables the disconnect and if a
break greater than 1.6 seconds is received, the modem will disconnect.
ATZx The Restore Profile Command resets the modem using the configuration profile
stored in non-volatile memory. The value "x" represents the configuration profile #0
or #1. If "x" is not designated, profile #0 is the default.
AT&Cx The Carrier Detect Override Command keeps the Carrier Detect signal set high when
the value of "x" is 0 (no matter the actual state of the incoming carrier). If the value
is 1, the Carrier Detect signal accurately tracks the incoming carrier.
AT&Dn The DTR Mode Command determines the action taken when the DTR signal changes
from a high-to-low transition. The values for "n" are defined as follows:
0
1
2
3
AT&F The Restore Factory Profile Command resets the modem using the factory
configuration profile.
Result Codes enabled are OK/0, CONNECT/1, RING/2, NO CARRIER/3,
and ERROR/4.
Result Codes enabled are OK/0, CONNECT/1, RING/2, NO CARRIER/3,
ERROR/4, CONNECT 1200 (baud rate)/5, and CONNECT 2400 (baud
rate)/10.
Result Codes enabled are OK/0, CONNECT/1, RING/2, NO CARRIER/3,
ERROR/4, CONNECT 1200/5, CONNECT 2400/10, and NO DIAL
TONE/6.
Result Codes enabled are OK/0, CONNECT/1, RING/2, NO CARRIER/3,
ERROR/4, CONNECT 1200/5, CONNECT 2400/10, and BUSY/7.
Result Codes enabled are OK/0, CONNECT/1, RING/2, NO CARRIER/3,
ERROR/4, CONNECT 1200/5, CONNECT 2400/10, BUSY/7, and NO
DIAL TONE/6.
Ignore DTR.
Go to the command mode.
Go to the command mode and disable auto answer.
Reset the modem using configuration profile #0.
19