Thermo Scientific V.22/212A User Manual page 15

Install the modem to the enclosure with mounting rails as follows:
1. Clean the mounting area of the enclosure, using the alcohol swab included in the kit, then
wipe the area dry with a clean towel before the alcohol film dries.
2. Remove the protective paper from the VHB tape. Ensure nothing contacts the tape
until put in place.
3. In one motion, set the modem with mounting rails in place and press down hard on the
four mounting screws of the board, securing the unit to the enclosure. Once the VHB tape
has made contact to the mounting area, do not remove it, not even temporarily.
Removing the unit from the mounting area degrades the adhesive strength of the tape,
requiring the tape to be replaced.
7