Continuous Drainage - Freecom SAF-Z80K2 Owner's Manual

CONTINUOUS DRAINAGE

In certain situations it may be more convenient to set the unit up for continuous drainage. A
hose with an inner diameter of approximately 10-10.5mm is required (not supplied). A typical
reinforced section of a garden hose would be suitable.
1. Ensure the unit is off.
2. Cut out the outlet at the back of the unit with a screwdriver.
3. Pull out the water tank and remove the rubber bung from the water
outlet at the back of the water tank.
4. Pull through the hose and connect to the outlet on the tank.
Retain the rubber bung for future use.
5. Push the tank back into the unit ensuring the hose stays
connected to the outlet. Make sure the tank is right position.
CAUTION:
If you wish to revert back to draining into the tank, when the unit is switched off and
unplugged, simply remove the drainage hose. Pull out the tank and replace the rubber bung
in the water outlet and push the water tank securely into place.
WARNING:
Please note that this appliance uses a gravity drain when on continuous drain. The hose
must be directed in a downward position.
8